Airmar Mix Match Cable f/Raymarine 600W Non-CHIRP Transducers [MM-RAY]

Get the perfect solution for your Raymarine 600W non-CHIRP transducers with this Airmar mix-and-match cable. These 600W transducers come with a common base and a short 2m cable, along with an 8m interchangeable brand-specific adapter cable. The transducer's short pigtail has an Airmar 5-pin male connector, and the adapter cable has a matching female connector at one end and the right connector for your electronics brand at the other. You need both parts for installation. And if you change your equipment brand later, just replace the adapter cable while leaving the transducer in place. Note: 600W mix-and-match cables aren't for 1kw or CHIRP transducers. Key features: 600W power and compatibility with Raymarine 600W equipment.

Using this Airmar mix-and-match cable for your Raymarine 600W non-CHIRP transducers is easy. First, make sure you have both the short 2m cable attached to the transducer and the 8m adapter cable. Connect the Airmar 5-pin male connector on the transducer's short pigtail to the matching female connector on the adapter cable. Then, connect the other end of the adapter cable to your Raymarine equipment. When installing, ensure all connections are secure. Remember, these 600W cables can't be used with 1kw or CHIRP transducers. If you change your equipment brand in the future, you don't need to remove the transducer. Just replace the adapter cable. To keep your cable in good condition, avoid pulling it forcefully and protect it from sharp objects. Also, store it in a dry place when not in use.