BEP 100A Engine Starting Intermittent Duty Solenoid [1002206]

100A Engine Starting Solenoid for Intermittent Duty

Use a low - amperage on - off switch to intermittently switch high - amperage loads. It's a great choice for engine starting.

Features:

• Designed for intermittent use (10 seconds ON, 20 minutes OFF), rated at 750A make/100A break, perfect for engine cranking.
• Operates with a 12V DC signal voltage and 6 - 12V DC contact voltage.
• Comes with #10/32 thread signal terminals.
• Has copper 5/16” - 24 thread contact terminals.
• The bracket mounting holes are 5/16” x 19/32”, 2 - 13/64” on center.
• It's the same as Cole Hersee part number M - 200.

WARNING: This product can expose you to chemicals like di(2 - ethylhexyl)phthalate (dehp), which is known in California to cause cancer, birth defects or other reproductive harm. For more info, go to P65Warnings.ca.gov.

This 100A engine starting solenoid is used for intermittent duty. To use it, connect the signal terminals with a 12V DC signal and the contact terminals with a 6 - 12V DC voltage. Then, you can use a low - amperage on - off switch to control high - amperage loads. Remember, it's for intermittent use only, so keep it on for 10 seconds and then off for 20 minutes. When installing, pay attention to the size of the bracket mounting holes. Also, be aware that this product contains chemicals that may be harmful. For maintenance, regularly check the connections of the terminals to ensure they are tight and clean. If you have any questions, refer to the California warnings at P65Warnings.ca.gov.